Fittings and Caps
Page Navigation
GENERAL OVERVIEW
Fittings and Caps can be used at both ends of the prop to help to spread the weight load (which can be considerable on multi-level cars). When using cordierite tubes as vertical props, the fittings also locate the tube in the correct position (via a recess in the batt, adding stability). We also offer a full range of splicers, allowing for multiple layers while supporting beams for heavy loads.
Many sizes and shapes of fitting are available to suit our range of tubes. The ‘effective height’ of each type of fitting must be considered when deciding on the length of tube required.
TECHNICAL INFORMATION
| Cordierite Fittings and Caps | |
| General Information | |
| Max Usage Temp. | 1300 °C / 2372 °F |
| Bulk Density | 1.85 g/cm³ |
| Apparent Porosity | 28 % |
| MoR @ 20°C | 15 MPa |
| MoR @ 1250°C | 13 MPa |
| CTE 20 – 1000 °C | 2.4 x10-6/K |
| Specific Heat @ 20°C | 1.0 kJ/kg.K |
| Typical Chemical Analysis | |
| Al2O3 | 37 % |
| SiO2 | 50 % |
| MgO | 8 % |
All figures are typical figures determined using laboratory test pieces and might not always be an accurate representation of production item.
PHOTO GALLERY
DOWNLOADS
- IPS Ceramics Cordierite Datasheet (PDF)
- IPS Ceramics Catalogue (PDF)
- IPS Ceramics User Guide to Cordierite and Mullite Kiln Furniture (PDF)
RELATED PRODUCTS
 |
 |
 |
| Fixed Posts and Flue Supports | Adjustable Props | Cordierite Tubes |